Should Metal Roof Overhang Drip Edge

Some slight overhang is recommended in conjunction with a drip edge flashing to prevent water from getting under the roofing and onto underlying wood.

Should metal roof overhang drip edge.

The edge of the shingles should hang over a roof between an inch and an inch and a half or between a half inch and three quarters of an inch if drip edge flashing is installed. A drip edge is a metal usually aluminum strip which extends beyond other parts of a roof and directs rainwater off the roof away from the fascia and into the gutter. Copper is a sturdy metal that gives a roof a unique look. Of course a drip edge should be flat on the roof deck.

Drip edge is a metal flashing that tends to overhang the sides of a roof. If the gutter is lower than the bottom edge of the drip edge install flashing behind the drip edge and over the back edge of the gutter to remove the gap. Too little can allow water to seep into rake or fascia boards. It has the main function of controlling water flow on the roof which has many implications.

Drip edge profile types. On 2020 02 20 by chuck. Although it does not look like much this component is made to have great structural integrity. Most homeowners will trust their roofing contractor to do what s necessary to replace the old roof but it doesn t hurt to ask if your roof bid includes drip edge.

Too much overhang and the shingles could blow off in high winds. If the overlap is too short fix it by placing drip edge under the first row of roof shingles and be sure that the exterior edge is reaching over the gutter. A typical metal roof overhang may be 2 to 4 inches or even less. When used as a drip edge it should be a minimum of 0 69 mm or 20 ounces.

There is a small size metal rim facing outwards and away from the roof fascia. If it s not that i suspect it was not properly nailed or was bent or damaged during installation.